...key pad lock twice but it still dones not arm. Best antitheft is a padlock and chain from the seat to the steering wheel ,visable and effective ,do not mess around with the factory system ,do not a ...
...replace the cylinder. You have to program the theft. When you replace the cylinder try to start the car and leave the key in the on postion untill the the theft light goes out and you shopuld be
...key in, and gently tapping on it with a piece of wood or the handle of a hammer. They are beginning to make ignition locks with tumblers spring operated, at right angles to the key, and they are very ...
program the ignition key If you have no warning lights, no power to solenoid then check negative terminal fixing from battery.If all is well, yet no crank, then replace starter motor and solenoid
...hammer while you hold the key all the way to the run position like your trying to start the engine. If they hit the starter and it starts, then replace the starter. Here's something else you can try. ...
...key in start position, rap lightly on starter with hammer to see if it kicks, if so, replace starter. i have a 1997 chevolet cavalier and it is having promblems cranking i drove it last night and at ...
...hammer to the car. I didn?t do any internet research on replacing the key cylinder until today because I figured it would be a big miserable job?but it wasn?t!!! To get to the cylinder, remove the 3 ...
Question about Cars & Trucks
...hammer, then turned the key over and it fired right up, ran good for about 30 seconds then died. Tried that process again and it will not start at all even if I hit the tank. Had someone turn the key ...
hammer at the ready! 1. Insert key in ignition and leave in the OFF position 2. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4. (Note port is
918 questions posted
Usually answered in minutes!
1,417 Questions
1,121 Questions
924 Questions
772 Questions
621 Questions