...brake light on one side, and a blinking light on the turning side. The rear turn signal lights and brake lights share the same filament in the bulbs (and the same wire). The wire on the turning side ...
...brake switch with a test light you should have power all the time on one wire and only power on the other wire when the pedal is pushed. if you don`t have power all the time check fuses, if you don`t ...
...lights work turn and park not the brake Replace the bulb - filaments could be faulty. check wiring on back side of the socket check brake switch is supply power to lights when brake pedal ...
...brake lamp switch on the pedal itself. You should have power on the LG/RD wire which comes from fuse 19 (20 amp) in the interior fuse panel. When you press pedal down power should then be on both ...
Question about Ford Ranger
...Light Positive Wire Location: At Switch Above Brake PedalFactory Alarm Disarm Wire (-): Dark Green/PurpleFactory Alarm Disarm Wire Location: Low In Drivers Kick PanelFactory Anti-Theft System: ...
...light bulbs also even though my old ones were ok. could there be a loose ground wire or a bad brake relay somewhere i do not know about? my truck is a 2003 ford ranger thunderbolt. u have a short ...
Question about Ford Ranger
...light and check voltage on fuse circuits. You have a starter relay, You could, for testing, unplug the relay, use proper jumper wire on load side of relay, the load side is terminal 87 and 30. It ...
...light would be helpful. In your vehicle since it says (See pictures below) on the passenger side it is natural to look on the right "kick" panel but where it is in your vehicle, if you follow the ...
brake with key on to "run" and move the shift lever all the way down to stops then back up to park turn key off
765 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions