2003 Ford Ranger Regular Cab "check cam shaft sensor" Questions

Ad

Question about Ford Ranger

2 Answers

up with fluid film or white grease.......Hope this helps. Check your battery, a bad cell could make the alternator work harder and cause the squeak. If battery's good try replaces the cam shaft sensor

Ad

Question about Ford Ranger

1 Answer

...up again. It still turns over but just wont start. Any ideas. Need to check your cam shaft position sensor. I just went through the same problem and had mine replaced and the truck starts no

Ad

check engine light then drove the truck around and the light comes back on with the same codes... Is it the cam shaft synchronizer its self? The truck idles fine in neutral but in drive the idle drops

...check engine light on? I think it probably is. If yes, then have the trouble codes read and report them back here for help with your diagnosis. My initial thoughts would be: 1. Catalytic converters ...

cam shaft position sensor that "comes to life" when rpms are up. or an injector has a bad spray nozzle allowing fuel to flow into its cylinder,pulling the spark plugs and checking for any that may be

...cam shaft crank shaft sensor? is this the same as cam shaft sensor?..2002 TB looses acceleration and stalls out. no each one has its own job, crank sensor is counting crank shaft rpms cam sensor is ...

...check the cam shaft magnet! And i have checked the cam shaft sprocket pin to make sure it was not gone " just in case the cam timing mark was off" i dont know what else to check here...... ...

Question about Ford Ranger

1 Answer

...is in and it still says its the cam shaft sensor. Help!!! PLEASE!!!! You always need to check the wiring system when you get a code and not just throw parts at it,I'm sorry this happened to

Question about Ford Ranger

2 Answers

...cam shaft sensor, check the wiring and confirm before replacing, if you have code P0011, or P0012 or P0017, this means that the cam variable timing in not working, oil may be too dirty or low oil, ...

...needs to be replaced. What is the real problem??? were the codes cleared after replacment if not try that if they were test the wires for cam signal and check for damaged ...

Not finding what you are looking for?
2003 Ford Ranger Regular Cab Logo

789 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...