1999 Ford Mustang Cobra "rotors" Questions

Is it best to replace the rear brake assembly -pads,rotors,calipers all at the sane time ? Normally, unless the caliper is not functioning or leaking brake fluid you don't have to replace it. Replace ...

...rotor how do i get the squeak off a glazed rotor? The best way, If you can afford it is to have the rotors turned, and sand the glaze off your pads, but if you can't have someone turn them then just ...

noise from rear brakes but pads and rotors are noise from rear brakes when not applied but pads and rotors are like new. Did you check the emergency brakes? The rear rotors have drum brakes on the ...

my steering wheel shutters when I apply the brakes. Your front brake rotors are warped. This can be caused by over-tightning the lug nuts or by high speed stops that overheat the brake rotors. You ...

I need to change the rotor on the front of a 2003 ford mustang Generally, there are two ways rotors are held on: First, the bridge holding the caliper has to be removed after removing the caliper from

2006 ford mustang. my front brake pads are touching my rotors when the brake is not applied. creates a bad squeel at low speeds and a light metal rubbing noise when turning sharply. the caliper ...

Element on distributor rotor keeps breaking off disabling the vehicle. How do you fix the problem? It sounds as if the distributor shaft is moving, causing the rotor contact to collide with the ...

I just replaced the rotors on my 2001 ford cobra and the back rotors were very tight. I have two questions. One, is it normal to have the back rotors getting so hot when driving and two how do I get ...

93 LX 5.0 Mustang, new fuel pump, rotor, and cap turns over well, 93 Fox body do u have spark? also the switch may be the cause of that as well, the switch is located at the bottom of the steering ...

I have spark at the cap but not to the sparks, already change rotr Ok, heres how the spark works, coil, to cap,, along the rotor to the connection pins of the cap, to the spark plug wires,, and onto ...