cars- Please could help me with the torque setting for Ford 3.4, V6 please specify what torque you need. The head bolt torgue? The lugnut torque? The motor mount torque. Every bolt has a required ...
Question about Ford Contour
Engine Torque SettingsCan you give me the torque settings for the head gasket bolts on a 1999 Ford Countour 2.0 liter engine. Need to replace head gasket and need the proper torque specs. Thank you. ...
what is the torque spec. for the oil pan, on a 1998 ford contour with a 2.5 v-6, auto trans? 18 Ft. Ib torque Spec let me know 25 NM
...bolts and bracket from the cylinder block. Reverse the procedure to install, noting the following: Torque the alternator bracket bolts to 15-22 ft lb. Torque the alternator bolts to 29-40 ft lb. ...
torque spec 96 ford contour 2.0 liter dohc head bolts Please don't forget to rate! 1st step 15-22 ft.lbs. 2nd step 30-37 ft. lbs. 3rd step Tighten the bolts an additional 90-120 degrees Do you need ...
can't get head bolts to loosen head bolts are torqued quite tight, use a snipe bar on your 1/2 inch ratchet to brake the bolts free, and observe very closely the sequence for reinstalling the bolts
...at 60 mph Check tire balance, outer tie rod ends, inner tie rod ends, ball joints, CV joint bolt torque at hub, and control arm bushings. You will find your problem some where in this line up.
...on? If so, read the codes. Is it possible the transmission is kicking in and out of overdrive, or torque converter lock up? If car has many miles on it, when did you last change the trans fluid and ...
...new fluid and filter because the screen could be plugged and not allowing the fluid to get to the torque converter also have the catalytic converter checked ...
...BOLT FILL WITH RECOMENED GEAR OILTILL IT OVER FLOWS INDICATING FULL REPLACE FILL PLUG(BOLT)Torque to ...
431 questions posted
Usually answered in minutes!
875 Questions
534 Questions
405 Questions
353 Questions
276 Questions