...FORD. You will most likely have to take this to a certified GM dealership to have the ignition replaced, sorry, no cleaver way to resolve this problem. Remove ign. lock cylinder code is stamped on
...replaced the starter. checked fusable link. tested ign. switch, str. relay. car won't turn over. are all the keys on the chrysler concordes have transponder keys? TRY THE NUETRAUL SWICTH REPLACE ...
replace the turn signal / high beam switch in the steering column Once you take off the cover, its pretty easy. To get the lower cover off I think the ign key cylinder has to come out. To get this out
...ign lock barrel will need replacing , will need to be done at a repair shop as need key inserted to remove, so will need a strip down ,a specific technique to remove when key won't go into lock is ...
...computer will not let the car turn over. you will have to replace the ign lock cylinder and have it recoded with the proper ohm resistor as the original key that came with the car. good luck. ...
...car still does not start. Alternator and starter brand new. Any suggestions Greatly appreciated. Replace ign lock cylinder and chip key. The tiny anti theft wires have broken going to lock
...Replace the ign. lock cylinder. Put old chip key in new cylinder. Plug it in to the connector at bottom of steering column by the dash after removing the wire from old lock cylinder. With duplicate ...
replace my ignition switch just remove the top and bottom plastic steering colume covers that wrap around the ign lock cylinder. than you will see from the bottom of the barrel where the lock cylinder
will not start tells me to wait 3 min. replace the ign lock cylinder and key. The tiny wires have broken going to the lock cylinder.
1995 Jetta key is stuck in ignition and won't come out lock cylinder has come apart must replace ign lock cylinder
301 questions posted
Usually answered in minutes!
316 Questions
136 Questions
161 Questions
115 Questions
112 Questions