1988 Ford Ranger "practice mate" Questions

...mate, you will have to remove the crankshaft pulley to be able to remove the cover to gain access to the belt. If you can't gain access to the pulley bolt or bolts, you will have to remove the ...

...from the outlet. Remove the gasket from the engine block and clean both mating surfaces. It is good practice to check the operation of a new thermostat before it is installed in an engine. Place the ...

how to change rear brake rotors 2004 gmc savana how to change rear brake rotors Removal & Installation CAUTION Dust and dirt accumulating on brake parts during normal use may contain asbestos ...

back rims are stuck on truck even with lugs loose and truck jacked off ground. I tried putting one lug back on loose and kicking tire and tried putting it in 4L and neither trick worked. Seems like ...

04 Jeep will not idle I have a 04 jeep grand and it sometimes will not start and when it does start it will not idle you have to feather the gas to keep it running. Also when you try and crank it all ...

yahoo.comhow do i replace fuel filter 1999 chev s 10 4.3 ltr. its located underneath the driver door on the frame on each side of the filter there is a squeeze tab squeeze them and pull the lines in ...

...from the outlet. Remove the gasket from the engine block and clean both mating surfaces. It is good practice to check the operation of a new thermostat before it is installed in an engine. Place the ...

...not even have lifters as some engines have camshafts that directly touch the valve stems. Common practice is to keep worn parts mated to each other. You would keep valve 1 in place to ride on ...

...parts store and ask for a new oil drain plug crush washer - most cars have them, and it's not a bad practice to change them every other oil change. If it's around the filter, either the filter isn't ...

...the left bottom corner of the head (that's the one that only gets torqued to 100.) It's always good practice to run a tap of the proper thread size into each bolt hole on the block and to use thread ...