1988 Ford Econoline "replace turn switches" Questions

...may have shorted out. As soon as you turn on the switch this rheostat comes into play and is probably whats blowing the fuse. I think if you replace the headlight switch, it will solve your

...out, but this usually effects both sides. A third problem could be the turn signal switch. The switch is located inside the steering column and does require some special tools to replace it. rate ...

Turning the ignition switch to start does not engage the starter The battery is charged, all electrics operate in the run position. It will start when the solenoid is jumped. I suspect a neutral ...

replace it if you can still turn the switch then your in luck. under the colum were the screws are to hold that cover there will be an blank hole. get something thats strong enough to push up and then

turn off the engine. it sounds like the small arm inside the steering colunm has broken. on my windstar it was actually two pieces. if you do not have tilt steering the job to replace it isn't too bad

...it might be the turn signal switch. He was not sure if the break light runs through the turn signal. are the bulbs good? Replace all the bulbs and if that doesn't work, check all the socket

...lights and reverse lights dont work. Turn signals and running lights work. All bulbs have been replaced. What should I check next? check the brake switch, above the brake pedal, one wire should ...

much cost replace starter my 1996 f350 econoline starter does not always engage when the key is turned. Usually jiggling the shifter lever will allow the starter to engage. Is there an issue with the ...

...relay and power. In the 1985 there are generally only 2 causes for this... (1) The ignition switch (replace it) (2) The wiring connections from the switch through the steering column. The switch is ...

...turn it to where it catches, it's fine. Does anyone know why, or if I can take my ignition out and fix the wires or replace the ignition cylinder? I have burned up one starter and don't want to do it ...