1988 Ford Bronco II "wont move" Questions

my ford bronco doesnt move idles great gears go in but wont movee is it the clutch or the fluids It would be the clutch not the gears.

...wont move unless i rev it over 300 rpms. but overdrive works fine I appreciate your request for my help.  However, for either personal or technical reasons I am unable to assist you at this

it wont move,what could make it not go is the torque convetor all the way in the pump.when the tranny is bolted up to engine& convertor unbolted can you spin it if not its not all the way in pump

...move idles great gears go in but wont movee is it the clutch or the fluids For this car, it can be really pricy or you can take my advise. I would recommend that you remove the 1 or 2 screws located ...

...drained and the transmission filter replaced and the box refilled, before it gives you more problems. If the vehicle fails to move you wont need to worry about passing any test with it. Regards ...

...wont turn flywheel starter motor weak. weak battery or engine is seized. take the spark plugs out and turn engine over with spanner on the bottom bolt on the pulley. if thats fine and move the engine ...

A4LD 4X4. trans. wont engage into gear I have a 1989 Ford Bronco II 4x4. Before I changed the trans. fluid it ran great. shifted a little hard but no big deal. After the filter and fluid change it ...

wont come with the slack adjusters. Make sure the adjusters are clean and move freely. Most adjusters are screw type, some (Ford) have rachet types. If they look worn, they are bad. Replace them also.

...wont move unless its in overdrive. The first step with any automatic transmission problem (if you haven't done it already) is to check the fluid level and quality. Inadequate or contaminated ...

1989 Bronco fullsize has sat for the past 6 years and wont start, will turn over, has new gas with fuel stabilizer, still no firing. Replacing spark plugs and the fuel pump are the next two steps. ...