pinion nut the torque There is no set torque for a pinion nut, it is turned until the crush sleeve behind it exerts the correct "preload" on the front Pinion bearing. The crush sleeve must be replaced
Question about Ford Cars & Trucks
...pinion nut and the crush sleeve from the pinion shaft. Remove the old pinion shaft and replace it with the new one. Reinstall the crush sleeve on the pinion shaft and install the pinion nut. Tighten ...
...nut PINION FLANGE & OIL SEAL CAUTION: Following procedure must be used to retain proper pinion bearing preload. Failure to follow procedure may result in premature axle assembly or component ...
Question about Chevrolet Cars & Trucks
Pinion nut torque for 1963 Chevy C-10 truck , 12 bolt rear end The best way is to use a new crushable sleeve between the pinion bearings,use red lock tight on the pinion nut and tighten the pinion nut
Question about Dodge Cars & Trucks
...pinion nut and crush slave out you have to disassemble the differential to remove the pinion gear to replace the crush sleave. to remove the pinion nut remove driveshaft then using proper size socket ...
...pinion nut. Remove flange with Remover C-452. Remove pinion seal with a pry tool. Removing the companion flange Measuring pinion rotating torque Pinion seal installer Tightening the pinion nut To ...
...pinion nut. Remove flange with Remover C-452. Remove pinion seal with a pry tool. Removing the companion flange Measuring pinion rotating torque Pinion seal installer Tightening the pinion nut To ...
...nut (pinion nut) at front of diff which is generally hidden when driveshaft is in place. with a bearing puller remove pinion bearing replace with new one, install new pinion seal reinstall pinion ...
Question about Holden Cars & Trucks
pinion nut enough to get a pattern/imprint of the teeth in the center of the pinion, you'll be spot on and adjusted. The pinion nut should be a ny-lock nut, with the nylon at the top of the nut cap so
pinion nut torque is 470 ft lb pionion brg pre load is 25-45 in lb Dana S110 pinion nut torque is 832 ft lb pinion brg pre load is 20-40 in lb Dana S135 pioion nut is 800 ft lb and pinion brg pre load
493 questions posted
Usually answered in minutes!
79 Questions
233 Questions
196 Questions
176 Questions
88 Questions