...ignition switch for the starting problem. The wire that makes the solenoid work comes from the s terminal on the ignition switch. The ignition (i) side of the ignition switch goes to the coil. The ...
...ignition switch Have been able to start truck w/ no key at times. Now key only goes in part way. Silver outside of ignition switch is loose and will turn completely around. Was in a front end ...
...it will continue running if I keep the ignition switch turned clock wise. I have found other people on forums with the same problem, but no solutions the problem is in the ign. switch. replace ...
...ignition switch, they separate and cause this stall out, try holding the ignition to the crank position just short of causing the starter to run, if the engine stays running then the ignition switch ...
...ignition switch again and the new boot may have problems in the solenoid that activates the starter switch or pedal switch clucht or if the transmission is automatic. It is important to check if you ...
Ignition switch cylinder has been replaced but problem remains. I turn key to 'on', everything normal. When I turn key to 'start' there is no resistance or springback and starter does not engage. 1992
Question about Ford Ranger
...ignition switch I have replace starter starter solenoid, ignition switch,cylinder key replacement, Clutch Pedal Position Switch. but still fuse# 24 (15amps) blows any ideas thanks There is a starter ...
1988 ford ranger no spark changed module on the side of distributor,replaced ignition coil,replaced coil in the distrubtor Did you replace the ignition control module, it is called the "TFI"? That is ...
Question about Ford Ranger
...problem, or maybe an ignition switch problem. The starting system is somewhat isolated and pretty much separate from the ignition system in general. This makes me suspicious of your ignition
842 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions