1987 Ford Bronco II "inertia switch plug wires" Questions

Ad

...inertia switch but I still can't get my truck to start. Any suggestions? Was the inertia switch actually activated? If so the button would pop up. You need to determine whether or not there is a lack ...

Ad

...inertia switch is the last component interrupt before the fuel pump, meaning the signal thru the inertia switch goes straight to the pump without stopping anywhere else. NOW, when you say you have ...

Ad

...Power comes from a fuseable link to the pump relay, then to the inertia switch on the dark green and yellow wire. Power from the inertia switch to the pump is on the pink blue or pink black

...inertia switch in the trunck no powere to it all fuses are good as is the relay At this point I would get a haynes manual from somewhere like autozone so you can get the wiring schematic. I believe ...

Question about Ford Bronco II

1 Answer

...inertia switch only stops the fuel pump from working. If the fuel pump is working and the engine runs then the inertia switch is working as it should. It has nothing to do with gas mileage. Make sure ...

...inertia switch, looked the 2 places another website said, but it is not there. Please help, my truck runs then shuts itself off and fuel pump is working. Please help, my truck runs then shuts itself ...

Question about Ford Bronco II

2 Answers

...inertia switch. The inertia switch is usually in the door pillar by the passenger's right foot. There are some relays by the flasher in the picture below. Check to see if any of those have the wire ...

inertia switch and the power for the fuel pump comes from that module. I would start by checking for a wiring problem. Below is a picture of where that module is located. At the plug of the module you

Question about Ford Bronco II

1 Answer

...inertia switch that needs to be reset? the basics are fuel air and spark, so check for spark by removing a plug wire and laying it on your engine close to bare metal and crank it , you should hear a ...

Question about Ford Bronco II

3 Answers

inertia switch and it's plug over time the plug and switch get warm and melts plastic plug causing a loose connection that continues to get worse until the truck won't at all ford sells the switch and

Not finding what you are looking for?
Cars & Trucks Logo

262 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...