Question about Ford F-150
...SPOUT connector inoperative my 1987 F-150 seems to be stuck at base timing, whether the spout connector is plugged in or not. I am wondering whether I should replace the spout connecter itself, or if ...
...1987 ford f-150 4.9l I-6, when the spout connecter is plugged in or pulled out the truck is always running at base timing. Not sure whether to replace the spout connecter itself or what? any help is ...
1987 2.3 4 cylinder ford ranger, the timing is good but i didnt disconnect the spout. what should i do 10 DegreesBefore top dead center*Base timing specification*Set at warm idle speed (electronically
trying to locate spout connector on 87 ford 4.9L pickup. I know approx. where it should be, but what does it look like? it will be in the wire loom coming of the distributor or ignition module, should
1987 Ford Ranger 2.3 liter timing 10 Degrees before top dead center, *Base timing specification *Set at warm idle speed (electronically controlled - not adjustable) *Disconnect single wire spout ...
spout connector located on Ford Ranger 1987 2.3L 4 cylinder. and what does it look like. Hello pennockgaryc: My name is Roger and I will help you. The spout connector will be taped to the wire harness
Question about Ford F-150
...WITH 2 WIRES GOING IN AT ONE END AND A TYPE OF CAP THAT LOOPS THE SIGNAL BACK.ITS CALL A INLINE SPOUT
cant locate spout connecter If it has a distributor, it's taped on the right side of the engine in/around the large wire loom that crosses to the right fender.. I have seen the connector melted on the
solved it.. i grounded out the map sensor the block the injectors the tranmission the water coolant spout everything..try it ;
1987 Chevy G20 van. How do I put power steering fluid in it? I've looked all over the engine compartment, but I don't know. Maybe I'm blind, But I cant locate the spout or resevoir. Also, I'm noticing
313 questions posted
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions