2003 Ford Windstar "noid light dim" Questions

...noid light, sold at all large auto parts chain stores.they are inexspensive.plug it in to an injector connector and have someone crank engine if it blinks then injector signal ok. the light will give ...

...noid light stays lit at all times Very low voltage light very dim Does it stay lit on all the injectors or just one? If it is all then it sounds as if the computer has an internal problem. Will the ...

noid light. If I open the throtel on the plentim and spray starting fluid or dump gas in, the car fires immediately. Is it the crank sensor, cam sensor, or e.c.u.? And...how do I check these parts and

...noid lights. If the injectors don't have pulse the engine won't start. ---------- This troubleshooting tips will help you to solve the problem.Thanks.Helpmech. your new starter could be bad. Yep new ...

...noid light. The injector gets unplugged and the noid light gets plugged in to the injector clip. With the engine cranking over, this light must blink. This is the signal to the injectors from the ...

...noid light when cranking. MIL light very dim. Unable to retrieve fault codes 12v either side of injectors, If efi fuse is put in and out the mil light will go bright, eng fires and runs a couple of ...

light, no sound, nada. The first thing you should do in this case is to pop the hood and check the battery. Either the battery is completely dead or there's a wiring problem in the starting system

noid light into the injector harness and its flashing dim and when the car gets warm and cuts off the light does also and will not light up till it cools off. it has new map,crank knock and tps sensor

...loose ground. i get one bright flash and a dim flash and noid light stays out i know the computer is good i put it in my other tracker and it ran Have you checked the cam and crank sensor Carl