2003 Ford Windstar "cv" Questions

...way it also rumbles and bangs. What is causing this? You could have a bad wheel bearing or a bad CV joint. Inspect your CV joint by turning the wheel all the way to the left and inspect the rubber ...

CV Joint on Passenger side is going tools needed to change a cv joint Nedle nose pliers or O ring pliers do remove CV joint

I need to know if special tools are needed to replace the drivers side CV joint on my 2000 Ford Windstar. I would buy a rebuilt axle half shaft from your parts store and replace. It is cheaper than CV

...driveshaft joint boot. Remove the stabilizer bar link at the front stabilizer bar. Make sure the CV-joint puller does not contact the transaxle shaft speed sensor. Damage to the sensor will

...is towed in Loud popping/grinding most noticeably heard when turning is normally a sign of a bad CV joint. Look under the van where the axle half-shafts come out of the transaxle and connect to

clunking sound under van when turning Your CV half-shafts and, possibly, your wheel hubs, are worn out. Replace your CV shafts. If it continues, replace your wheel bearing hub assemblies.

I have a passenger side clunking noise when moving forward and turning. I changed the CV axle and the noise is still there. Could my new CV axle be defective? I had a similar problem on my 2002 ford ...

...Yes they (UNIVERSAL JOINTS) do... but I pulled up your car on-line and IT APPEARS you have CV-Joints (on your "half shafts" (axle, each side)). So do CV-joints (constant velocity joints) ...

...but I think you are getting in over your head. There is nothing telling you the condition of the CV joint you will be removing (Constant Volecity) (Knuckles?). This is a big job requiring special ...

...had only neutral. could this be just a plug? or a fuse? the only thing i can think of it being is a cv joint.The cv joint goes from the tranny to the front tires.Does the engine reve up when you give ...