2001 Ford Windstar "ground wire location abs module" Questions

Ad

Question about Ford Windstar

1 Answer

...ABS brake system which are powered by fuses 101 and 102 and are both 40 amp. The fluid attacts moisture, road salt and leads to a fire when the fluid and moisture act as conductor between the hot ...

Ad

Question about Ford Windstar

4 Answers

...ABS LIGHTS AND BRAKE LIGHTS ARE ON, THE O/D LIGHT IS FLASHING. IS THIS A MAJOR CIRCUIT FAILURE, OR SOMETHING THAT COULD BE A QUICK FIX? check your electrical diagram or take it to a mechanic! Check ...

Ad

Question about Ford Windstar

1 Answer

...ground wire connected to the engine block. Look for it on the back passenger side of the engine towards the top. Remove it and clean the connection and the wire connector and replace. Sometimes they ...

...ground wire location Hello Jim, The ABS Brake Pressure Modulator Valve - G105 (Engine Ground) Brake Pressure Warning Switch - (Engine Ground) What problems are you experiencing? ABS Light On ...

Question about Ford Windstar

1 Answer

wire (12-gauge). Disconnect the ground from the rail and use a "whiz wheel" to clean the area in front of and behind the ground connection. Now get a bolt, two star washers and a nut. Install the bolt

Question about Ford Windstar

1 Answer

...there is a loose ground wire. (you will need to retrieve wire schematic and check all ground locations in engine compartment and near computer. The abs module may be faulty if all grounds are

trying to program it and you have to ground a wire in the computer module ccr? where is that located on a 1990 reatta In the trunk......near ABS module....wire with green connector.

...ground, the next think to look at would be the modules and/or sensors to make sure they're operating within spec. U1003 Possible Causes: *Faulty Anti-lock Brake System (ABS) *Module Anti-lock Brake ...

Question about Ford Windstar

1 Answer

during the self-test. Cause(s) A connector terminal is corroded. The wiring harness is damaged. The ground terminal is not conducting properly. The EBCM is defective. the relay is internal to ABS unit

ground wire. There is one located on the top rear of the engine block. It is a bolted connection. Remove this bolt, clean the surfaces and replace. This simple step has cured many electircal issues on

Not finding what you are looking for?
2001 Ford Windstar Logo

2,720 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Windstar
1998 Ford Windstar

1,830 Questions

2000 Ford Windstar
2000 Ford Windstar

1,503 Questions

1999 Ford Windstar
1999 Ford Windstar

1,212 Questions

2003 Ford Windstar
2003 Ford Windstar

1,032 Questions

1996 Ford Windstar
1996 Ford Windstar

600 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...