2000 Ford F150 Flareside SuperCab "intake manifold boots" Questions

...intake manifold at rear of engine, passenger side. Super hard to get to. you cannot see it. You have to do it by feel. After a startup backfire, mine popped off. My mechanic couldn't find it, but a ...

...intake manifold leaks, or any vacuum suply hoses leaking, including the brake booster hose or even a leaking brake booster. Low fuel pressure, caused by any one of several reasons, can also cause ...

intake manifold. DO NOT USE THREAD SEALANT, 2002 has the better heads over older 4.6/5.4 but you can strip out the threads, requiring expensive re-threading/helicoil repair. be sure to use di-electric

...intake manifold under the coils, the rear ones are a bit tough to get to, be patient. you do want to grease the boots that slip over the plugs under the coils. you first take off the gas cap to ...

intake manifold througn a thin plastic line.  The mode switch puts the vacuum to different doors in the heater box to redirect the airflow.  Each door is operated by a vacuum actuator. 

...fuel air and a good spark it should run even if you had a trained monkey sitting under the hood pouring gas into the intake manifold with a tea cup unless the exhaust gase's can't get out of the ...

intake manifold plenum boot and the gaskets. Now the car is blowing white smoke from the back and overheating after driving for abourt 30 minutes. check system light is continuosly blinking on and off

The plenum boot between the intake manifold and throttle body is leaking vacuum. How do I get it out to replace? Hello, You have to remove the intake manifold.

...from the air filter housing to the throttle body. there are lots of vacuum lines all over the engine usually running from the intake manifold in some fashion. they are black rubber or molded ...

intake manifold. 2.The PCV valve is sealed to the intake manifold with two O-rings. 3.Free the PCV valve by rotating counter-clockwise 90 degrees until the locating tabs align with the openings on the