2000 Ford F150 Flareside SuperCab "head" Questions

i have a 1990 F150 tuck and i need head work to , my question is do i need to do , one side of my tuck gasket are do i need to do boif side ,/ it a 5/o motor This depends on what you need to do. If ...

...in cylinder #3. Anybody know what to do or how to fix this?? PLEASE HELP!!!!!!!!!! you have a blown head gasket You will have to take the cylinder head off and replace the head gasket-it is probably ...

Head gasket torque specs Need the head bolt torque specs for a 1990 Ford F-150 4.9 w/ inline 6 Here you go, I hope this is what you were looking for: For 1987-94 models, the cylinder head bolts are ...

...on 5.4L, where is it located? its not a true coolant temp sensor. you are looking for cylinder head temp sensor. it is located on the driver's side head, at the front, on the inboard side of the ...

water coming out of the exhaust and over heating?? what could be the problem head gasket, or cracked head. confirm with a pressure test of cooling system Sounds like cylinder head gasket.

i have white smoke coming out of my 88 F150 any thoughts? out of the tailpipe?  = blown head gasket, warped heads, and worst case cracked head or block(internal).

...AND THE WATER GO OUT FOR THE PASSENGER MUFFLER SIDE 97 FORD F 150 It sounds like you have a blown head gasket or cracked cylinder head. These are usually caused from the engine over heating. if the ...

...cd changer If it is an aftermarket changer, it will usually be in the power wire for the control head.  If the control head is lit, it could be a faulty ground wire or the control cable is ...

I have 4.9L6 need torque specs for cylinder head I have 1988 F150 4.9L6 need torque specs for cylinder head and rocker arms for cylinder head the torque is : step 1 55 ft-lb, step 2 65 ft-lb, step 3 ...

1997 ford f150 4.6 4 wheel drive torque spec for heads from autozone.com: Tighten the cylinder head bolts in the sequence shown in three steps, as follows: Step 1-27-31 ft. lbs. (37-43 Nm). Step ...