1997 Ford Ranger SuperCab "clutch" Questions

clutch would not disengage The clutch was replaced but would still not disengage. The clutch pedal goes to the floor with no resistance. the hydraulic system was bled several times. Still the clutch ...

Having problems with the clutch in my 1998 Ford Ranger. There is no freeplay, and it is very difficult to shift. Do I need to adjust the clutch? If so, how do I adjust it? The clutch is not adjustable

My 1984 ford ranger clutch is slipping, How do I adjust the clutch to see if this solves thr problem before I buy a new clutch ten years is about all the life you can expect out of a clutch, your car ...

Truck wont go when I release the clutch. When I go to take off my truck goes into gear fine but when i release the clutch the truck wont move. Sometimes it will grab and go just a little bit but not ...

Clutch Problem-Clutch is acting as if it does not fully disengage when it is let out fully-just started doing this yesterday with no adjustment to the clutch performed by me. If the clutch is a manual

clutch lets out at the very top of the pedal when i drove the 4wd ranger i found that the clutch is difficult to let out on take off and stalls and will not let out going up hill. I want to know if ...

2002 Ford Ranger Clutch Problems My 2002 Ford Ranger is having clutch problems. When I push in the clutch in order to switch to first gear I can't push the stick in. There seems to be no pressure in ...

My 1991 Ford Ranger Clutch Problem. My 1991 Ford Ranger will not start. I am not sure if the clutch is shot or if there is air in the hydraulic line. I aslo don't know how to check either. Any ideas??

what are the symtoms of a bad clutch switch If the engine revs up more than normal and your not gaining speed then the clutch is slipping.If you shift down to pass and then try to accelerate and the ...

...94 manual transmission Ford Ranger located in a cold climate. All of a sudden, when you step on the clutch pedal there is no resistance. Suggestions on what this might be? you need to check the fluid ...