1996 Ford Windstar "location intake manifold runner sensor" Questions

intake manifold runner controls are stuck open.They are controlled by vacuum solenoids.The P0171 is bank one of the engine is running lean,usually caused by a vacuum leak, P0420 is catalytic converter

...Intake Manifold Runner Control IMRC maltfunction (Bank #1 stuck open) Look down in the very back of the engine behind the intake manifold. You will see 2 linkages coming out of a box looking piece ...

...intake manifold supports.8. Remove support brackets at the intake manifold front corners and MTV.9. Loosen upper fastener attaching throttle body to support bracket.10. Remove clips attaching EGR ...

...INTAKE MANIFOLD UNNE POSATION SENSOR CODE P2025 Your intake runner sensor is located on the side of the intake look where the vacuum lines go to the vacumn pod and kinda follow it look at the linkage ...

...Intake manifold Runner Sensor Bank 1 open- this sensor is located on the throttle body of the intake, make sure the wiring is not corroded or breaks in the wire connecting to it.If there is power ...

...intake manifold where its mounted to the engine there should be 4 individual sensor looking components(one for each cylinder) with a 2 wire connector fastened to them,then you have multi-point ...

...know what model radiator to purchase? I only see 4 connections..in/out, trans in/out and overflow. thanks the coolant sensor is located in the coolant pipe under the right side intake manifold

...the coolant temp. sensor is located under the intake manifold at the runner for #1 cylinder. It maybe hard to access. Try going throught the right side wheel opening over the tire it is a tight

...intake manifold runner control system. The operating solenoid would have to have been disconnected for intake manifold removal. It may have not been plugged back in or the solenoid may be defective. ...

...intake manifold runner position sensor located on 2009 Avenger Are you looking for the throttle position sensor? It would located on throttle body where the wire from the gas petal goes idle air ...