1996 Ford Windstar "bar holds axle straight car" Questions

bar. Do not take the lug nuts off the studs yet. Position a jack under the van and raise it, lifting the van until the tire is off the ground. Slide a set of jack stands under the rear axle of the van

...bar, and do not want to over do it to crack the transaxle case. Has anybody encountered this before? How was it resolved? The axle must be removed in a sharp snapping motion and it must be pulled ...

...-pull axle shaft out of transaxle (it may be necessary to use a pry bar inbetween the transaxle and inner cv joint. be carefull not to crack the transaxle housing) it should just pull straight

...bar to pop out of trany, install new axle hold straight and slide into tray as far as you can then with nut on the axle a little tap to axle in to trany the rest of the way you will feel it go in and ...

...bar will pop it loose it will have a round wire clip on the end of the axle ive also had to use 2 pry bars to evenly pull it out and installation is easy as a few smacks on the end with a brass or ...

...holds axel onto cv joints-or motor is it a push pin or do i need to release it with a allen wrench or star wrench. How does it release from motor? Most of the axles I have pulled out only take a good ...

...axle is a little tricky I use a crow bar and tuck the curved end in behind the cup of the axle then look for a good sturdy position on the transmission and do a quick snap on the crowbar and the axle ...

...axle out USE A PRY BAR IT SOMETIMES STICK BECOS OF THE HEAT To separate the axle from the transmission you will need either a large flat blade (standard) screwdriver or a pry bar. Slide the pry ...

...put a block of wood as cussion under the bar. It would also help to have one of your freinds over to help hold the axle out as straight as possible in order to take any extra load off the inner

bar to sperate the control arm from the spindle, pull spindle out and slide axle out of the spindle.to replace the boot cut the inner and outter boot clamps, slide boot back and look inside for a clip