...timing light and a 1/2 inch or 13mm wrench.1. Take a rag and clean the timing marks on the pulley and the timing cover. If you have any white out type correction fluid, you can also paint the ...
...light works intermittently sometimes it is ok other times it makes a bu8zzing noiswe and will not go on It's an easy fix for me. I hope it work for you too. There are two parts you need to look into. ...
Question about Ford Ranger
...2 wheel drive. This morning on way home on interstate the engine cut out the abs light came on then engine took off running again the abs light stayed on I pushed in the clutch shut off engine ...
...2 times til it starts to idle properly. The check engine light comes on as well as the battery light. I've replaced battery connectors and the terminals are clean, spark plugs are new, the battery ...
The head lights have gone out, the full time bright lights quit working, all the other lights work, I do not have the owner manual and cannot figure out if it is a fuse or switch, I do not have a map ...
...timing light at the marks and pointer.see emissions label under hood for exact timing Specs. 9 if the marks don't line up shut down engine 10 loosen the hold-down bolt on the distributor base but not ...
...2 hr. called for tow home started next day runs fine but afraid to drive ant distance now. BTW no chk eng light either. Sorry to say someone will have to have tools ready to check it the next time it ...
...down #1 post and mark your housing. Remove cap and turn dist until rotor centers on mark. Start and time (remember to remove timing plug) with timing light. Did you remember to use new head
...2 hr. blew again.replaced again...after about 15 min it blew again...try'ed replacing again.as soon as is try'ed it would blow/.i unhooked the tail light ***. it still blows it.so i know it's not the ...
891 questions posted
Usually answered in minutes!
642 Questions
645 Questions
562 Questions
558 Questions
477 Questions
