1991 Ford Ranger Supercab "gear box" Questions

...the truck go into reverse, drove home like normal and then truck would not go into reverse again. if its an auto box have a look at the gear leaver on the gear box it may just have come loss on

...box) when iam driven my Ford Ranger XLT 2001the gear stick makes a strange rateling sound when iam in 5th gear could you tell me what it could be please If you haven't done it lately, it's time to ...

...gear box. When I accelerate for a long time, on a highway for example. I start to hear a high pitch noise. It doesn't sound super bad. It starts out quite and gets louder. If i stop ...

...gear box is in neutral due to misalignment of shifter. Going with your theory, failure of shifter to "catch" and slide gear sets could happen if everything was not preperly aligned to neutral before ...

...gear box if you have replaced the clutch , t will be a clutch plate put in back to front If it is hydraulic clutch ,it will be a master cylinder or slave cylinder problem if it is cable clutch , it ...

gear box, its like oil seal for engine you can get it for engines gear boxes and difs and power steering. it sometimes goes by seek and seal, in older vehicles its quite good. you will need to replace

...box and one gear was selected and the end of the lever came out of the selector slot or all the selectors were not in the neutral position and so the end of the lever went behind a selector rail pull ...

...gear box. the syncromesh is a small clutch like part of your gearbox if this has stopped then the gear selection will be jumpy they call this crunch gear box. either way you will most likely needs a ...

gear but a sliding dog that locks the input shaft to the main output shaft making te drive a complete shaft that means that there is no side load on the bearings and so the noise stops when all of the

...gear box heating up would check fluid level Sorry to hear this no shift problem. The shift fork gets hung up from slack caused by wear. In some transmission it like 3rd gear or 4th gear that grinds ...