1988 Ford Tempo "2 electronic ignition wiring" Questions

...1 & 4 Swap your sparkplug cables #1 with #2 and #3 with #4. If #2 & 3 still don't spark, then replace the electronic ignition module. If 2 & 3 spark, then replace sparkplugs and/or

2. Bad or misfiring Wire going from the #1 on the Distributor/Electronic Ignition Coil to the #1 Cylinder. 3. Misfiring at the #1 on the Distributor/Electronic Iginition Coil. a. Unplug the #1 Wire at

...electronic unit available are 1) yelow with two blue stripes 2) black with two white stripes. which goes where please! URGENT.Thank you the yellow blue is the + side of coil but to be safe get a test ...

...start it after checking the cylinder compression it would not start there is no spark to the going to the distributor 2.l fuel injected electronic ignition Fixya doesn't have wiring diagrams. ...

...2) electronic ignition, but lack of spark problems are usually a faulty coil on traditional vehicles, and on the newer electronic ignition cars, total lack of spark would be a faulty ECM (electronic ...

...electronic control unit. Hi The Metro is quite a simple car in regards to electronics. There is an ignition fuse. it might be the problem but also check the wiring to the distributor cap and the 2 ...

...electronic ignition? The "instructions" only show how to hook up to standard ignition. Hello! Your vehicle is equipped with a distributor-less ignition systems; C-31...Does your engine have ...

...2 Plug Black ignition module. One plug has a green wire & a grey wire Second plug has 4 wires: red white orange & purple Need to know how to wire correctly to battery for swamp buggy Ford has ...

Electronic Control Module (ECM) is continuously monitored. The test fails when the signal indicates that 2 successive erratic profile ignition pickup (PIP) pulses occurred. Symptoms: - Engine Light ON

...mean from the igniter. It goes to the tachometer.and the AC amplifier.The other black/red bring +12V to the