1988 Ford Escort EXP "1983 engine removal" Questions

head lights blink on and off after about ten minites Hello lets start in your power distribution center under the hood engine compartment behind your battery it is a black box with your head light ...

...1983-90 1.6L EFI and 1.9L EFI engines: Thick Film Ignition IV (TFI-IV) System Disconnect the negative battery cable. Remove the distributor from the engine. Place the distributor assembly on a ...

1983 silverado rear main seal leak how to replace it For this to be done you must purchase a rear main seal by visiting your local parts store and then you must incline the engine remove drive shaft, ...

...1983 ford mustang 5.0 i hate to say it but... i recommend pulling the engine out and putting it on an engine stand. while it is out replace crank seals and inspect freeze plugs. Step by Step ...

...1983 bronco ll will have to switch distributer out on 2.8l engine to get rid of computer and sensors but need what distributer will match engine without electronics there was no distributor that ...

...1983 south wind rv it has a 7.4 engine but no smog pump, i need to put it in If you are saying that it was removed, did they block all of the hoses and vacuum sources as well? If it's all intact and ...

...engine. 1983 model and have to replace the front crank seal. how much trouble is it?I already have the radiator off and replacing it. You'll need to remove the crankshaft pulley and the harmonic ...

...on a 1983 jeep cj7 I suggest visit autozone.com (free register) abd select the year, make, model and engine size for free access to this information. Hope this help (remember rated and comment

why my 1983 cutlass oldsmobile engine light is on after i have done tune up. Try resetting codes in computer by removing ground cable from battery and leaving it off for 1 hour.

I have a 1983 Dodge one ton with a 360 4 speed the Engine Maintenance light just came on. How do you reset it? I "heard" if you remove the battery cable for a short time, it should reset.