1984 Ford Econoline "replace head gasket 84" Questions

...head gasket blew and i need to replace it. I know that I need to replace the intake manifold gasket, valve cover gaskets, and probably the water pump gasket because they cant be put back on without ...

...head. Could also be a bad intake gasket. Do a compression test to verify which. TELL ME WHAT ALL YOU REPLACE.IF CARBURETOR POPPING YOU GOT VALVES STICKING OR BROKE SPRINGS OR VALVE TIMING IS OFF.DO A ...

...a super high rpms and overheats I don't know what the problem is sounds like mass airflow sensor or vacuum leak check intake gasket for air leaks you might have a bad head gasket also check ...

...head gasket will sometimes cause air to bubble into the coolant system. If it bubbles over when you start the engine (cold), then there is probably a bad head gasket. If the usual things (thermostat, ...

head gasket UNTIL you have worked thru the basic coolant parts one by one. Get a new cap, top up coolant, start car with no rad cap and let run for about 15 mins, sqeeuze your lower rad hose under the

...replace with the engine in the car. If doable It looks real hard to get to. Any advice from anyone has done it would be appreciated. 84 Porsche 944. blown head gasket or intake manifold gasket will ...

head gakets on my 84 Bronco II put all back together. It will start, pumping on the accelarator but it will die.Could it bet the distributor is off its mark? I marked the manifold and the distributor.

head. (b) Disconnect the water inlet pipe and remove the 0? ring. 5. DISCONNECT ENGINE COOLANT TEMPERATURE (ECT) SENSOR CONNECTOR 1MZ?FE ENGINE ? COOLING SYSTEM EG2?329 (c) Check the valve lift. Volvo

...replace it with new one. These are cheap parts! normally temperature should be 82 degree to 84 depends fan switch situated anywhere near radiator and u need to check thermostat and radiator blocked ...

...head gasket problem. Check the coolant - do you see any oil in there? Also, after you drive it for awhile and return home, park it with clean cardboard under the engine on the ground, so that if it's ...