1989 Ford F 250 "460 fuel pressure" Questions

Ad

...1989 f-250 460 fuel injected replaced inline electric fuel pump fuel filter fuel regulator fuel pumps are pumping but truck acts like its starveing for fuel as soon as Istep on the peddle need ...

Ad

...460 gas motor, it starts but after 1 or 2 seconds it dies, can pump peddle to 2500 rpms but surges between 2500 and 2000 rpms, changed fuel filter, still have problem, any ideas.....Thanks Steve Fuel ...

Ad

Question about Ford F-250

1 Answer

...460 starts and runs for about 30 sec then stalls. I leave the key on and wait a few sec and it runs for another 30 sec. or so. I've replaced the fuel pump in the midship tank and I can hear the tank ...

Question about Ford F-250

1 Answer

...460.no fuel to carb. was told i had very low oil pressure.would changing oilpump and assending unit fix my propblem? do i have to pull motor to change oilpump? what causes pump to go bad? If you're ...

460 gas motor, it starts but after 1 or 2 seconds it dies, can pump peddle to 2500 rpms but surges between 2500 and 2000 rpms, changed fuel filter, still have problem, any ideas.....Thanks Steve SOUND

Question about Ford F-250

1 Answer

...460 gas motor. Help? did you check the o2 sensor bank 1 ? cause de p0171 code say sistem too lean bank 1 do you need replace this sensor and get a better fuel saving . or maybe is disconected or the ...

...460 engine and duel tanks it is factory fuel injected.....the front tank ran out of gas so I switched it to the rear tank( the same as many times before) the truck died and won't restart. I changed ...

460.it has fuel pumping to the carb. as long as it is cranking,but as soon as it starts and I let the ignition go to the run position the fuel pumps stop pumping.It then runs till the carb.runs out of

...460 engine will crank but will not start. i checked high pressure fuel pump and no power so wired direct. i checked and had power at fuel injector harness, getting fuel, but will not start. put new ...

...460 automotive fords were fuel injected. Carb Solutions do not apply. Use FI troubleshooting techniques. Does it fail due to fuel or voltage? Jumper the fuel pump pin in the computer access connector ...

Not finding what you are looking for?
Cars & Trucks Logo

496 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...