how do you change rear axle seal on 1993 f 250 pull rear cover, pull center pin bolt out, pull pin, push axle in to drop clip, pull axle out, remove old seal, install new one and reverse above
change rear whell seal 1997 f-150 gear oil comeing out of rear whell took tire off; took drum off; and saw gear oil all over brake shoes. Seal or bearing need to be replace? how? replace the axle seal
...it. I have a 1998 ford f250 power stroke diesle So the light was on and you changed the bulb to fix it? You may have a ABS Wheel Speed Sensor bad. the one located in the rear axle is common to go
...f250 4x4 long wheel base rear shaft my old shaft is worn out @the yoke and spline. i would like to know if anyone in Tucson custom builds shafts.i live close by. i changed motor tranny and transfer ...
...wanted manuel hubs anyway. replaced them with warn manuel hubs. still not working. have recently changed gear oil in front and rears and on inspection all looked good! when i push the button to go ...
...rear drive shaft turns when truck is in gear but no move how easy is it to change out the pinion gear? not a good idea to chg. just pinion, best to chg. both ring and pinion, and for that you will ...
rear axle speed sensor. The generic electronic module (GEM) receives this signal (VSS_GEM) for internal use and then distributes it to the appropriate other users (i.e., the powertrain control module
...truck i replaced the sensor on top of the bell housing and nothing change what can i do next thanks,charles. CHECK FOR A SENSOR ON THE REAR AXLE AT THE RING GEARM OR ONE AT THE TAILSHAFT OF THE
Question about Ford F-250
...rear tire off truck, lugs are off but tire is not loose, whats holding it up if the car has high mileage etc try spraying wd 40 around the hub and from behind hit the rubber of the tyre with a copper ...
178 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions