1979 Ford F 350 "replace blower motor" Questions

Ad

BLOWER MOTOR Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual

Ad

...blower motor,the vacuum pump has to be moved out of the way(10 mm bolts) . There are three or four 8mm bolts holding the motor in place. make sure you have power and ground to blower motor before ...

Ad

...here it out side the truck on high. The fan control switch has all 3 speeds, do I need to replace the fan / motor Details are in the question title. check it for trash no trash replace the blower ...

...replace the resistor. Look under the hood, generally the wiring for the Blower resistor is attached to the wiring to the blower motor itself It's inboard & below the motor, near the accumulator. ...

Question about Ford F-350

1 Answer

motor My a/c blower motor is squealing like a pig. I can get to it but not sure how to pull it? I took my truck in and they removed the blower and cleaned it now works great did not need to replace it

...This is one of two failures either the front power transistor or the blower motor. If the power transistor is failed, then the blower motor has to be replaced also. This is a very common

Question about Ford F-350

1 Answer

...blower motor relay (small metal box 2" by 2") located on the passengers side radiator support tucked down low behind the headlamp area. It was hard to reach and I did replace a few of these way back. ...

...it?? lift the hood go to the pass. side of truck . the blower motor should be on the firewall with 2 big size wires , remove the plug , and all the screws pull it out , replace........reverse the ...

Question about Ford F-350

1 Answer

Blower motor resistor replacement where is a blower motor resistor on a '05 ford 350. i know it is under the dash behid the glove box but where? photo? Not the best pic in the world, but here it is. ...

...replace heater blower motor on a 1978 f150 non ac truck? locate the motor , unhook the wires , take off 3 or 4 nuts ,install new motor,tighten nuts,put wires back on and your good to go!!! (motor ...

Not finding what you are looking for?
Cars & Trucks Logo

136 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...