2002 Ford F150 Regular Cab "fuel tank gas release" Questions

fuel tank on the driver side. It's tucked inside the frame. You'll need to go to the parts store and get the special tool to release the lines. You push the tool in where the lines and the filter push

...fuel pump is in the gas tank and i cant get the fuel line off the pump if you have the right tool that slides over the metal line and into the coupler to release the enternal locks then i suggest you ...

Fuel tank sending unit wrench number 310-123 Screwdriver Slip joint pliers New O-ring seal Clean engine oil. Steps to replace fuel pump: Detach the splash shield from the frame rail located underneath

...tank on the driver side. there is a special tool needed to release the fuel line connections. here is a link to a youtube video that shows one being changed. How To Replace the Fuel Filter in 1997 ...

...fuel vent system My 2004 Avalanche does the same thing, but air doesn't rush out when I open the cap. After examining the system, I believe the problem to be the very small diameter piece of tubing ...

...fuel filter---if it close to the gas tank--remove the 2 nuts that hold the fuel filter bracket to get more room--any auto parts store should have the tool--install around fuel line & push towards ...

...tank to draw from point is i finally replaced the switch and it ran, but still ran rough, (2) on the left side of the motor their is an EGR valve (it was green colored vacum hose) I replaced that ...

...tank of fuel run through isn't enough if the truck is old and resting. 4.9 runs strong, then jerked and stalled. Let it rest a day and it was fine for another 2 miles. Pop and jerk like it was not ...

...fuel tank clogging you fuel filter... so check that as well. the fuel filter is usually the cheapest to change... if this doesn't help the only thing i can think of othe than that is check your ...

...tank fuel pump. I have been trying to get the quick connect to release so I can release the fuel pump on the ford and it is not releaseing. Are you using the proper quick disconnect tool and size. If ...