i have a 99 ford contour, my check engine light came on and ran the code p0102 which is the MAF sensor. I replaced the MAF and my car still runs horrible (idles rough and wants to stall around 10% ...
...motor to see if you have increased pressure in one of the cylinders. All the cylinders should register within 10 to 15 lbs of each other. If you have one or more that is greater than the rest the ...
10 years is all you can ask for in a lift motor so go on ebay and buy a new regulator and pay a glass shop to install it for you. will save you hundreds over a dealer and lots of aggravation in trying
Question about Ford Contour
motor R16 Black Ignition R17 Unused R18 Black One touch window switch Driver's door R19 Blue Cruise control cut-off Central fuse box bracket R20 Unused R21 Unused R22 White Fog lights Interface module
MOTOR. IT IS A $10 DOLLAR FIX WITH LITTLE EFFORT. Easy fix mate... Take the Glove Compartment out to gain access to the heater/blower moter. On the motor housing is the control speed resistor. Usually
...Motor home on a Ford Chassis w/ V-10 Engine and Auto transmission. Recent, My battery went Down and Upon Re Charging it, My Speedometer Stopped Working. Everything Else in the Cluster Works fine, ...
...motor solenoid. Tighten the battery cable retaining nut to 12 Nm (9 lb-ft). Tighten the solenoid terminal retaining nut to 5 Nm (44 lb-in). Install the transaxle selector cable bracket. Tighten the ...
...10 mins. or so. Cranks but won't start. Seems to be intermittent problem. (happened last week 1 time and after an hour or so it started. Fine all week - just happened again). What could be causing ...
...10-15 minutes, it finally kicks in. I can feel the heat when I start the car, but it is very faint. Any ideas? My thoughts were either a blown fuse, replace the blower motor, or replace the resistor. ...
807 questions posted
Usually answered in minutes!
875 Questions
405 Questions
353 Questions
309 Questions
276 Questions