...replace the control arm for the lowers as well, but that's BS. They can be replaced fairly easily with the proper tools. all yall the upper is like jymms said ive been in this buiss. along time , the ...
...replace front struts, CV joints, inner and outer joints, ball joints, stabilizer bar bushings and lower arm bearings. When i pass over road joints, uneven roads and bumps the whole car vibrates. Also ...
...Lower Arm Ball Joint 7 3105 Front Wheel Spindle 8 642569 Cotter Pin 9 3304 Steering Sector Shaft Arm Drag Link 10 383489 Nut 11 3001 Front Axle Assembly 12 388727 Bolt A - Tighten to 77-103 Nm (57-75 ...
Question about Ford Ranger
...replace the axle and I had to pry a little to get the lower ball joint back on. Do you think I need a new lower ball joint? Is there something that is making the brakes grind against the rotor at a ...
...springs, then there are adjustable upper control arms and ball joints available. These do generally only address the camber angle, not caster, which can also greatly affect handling. hope this
...replace the upper and lower ball joint when you had the other stuff done try that. is hard to figure it out you problem sr. but my shop is at minnesota if you live in this area i would check it ...
replace wheel hub . End play is not adjustable. If wheel hub is disassembled, the assembly must be replaced. Remove all foreign material from knuckle bearing bore for correct seating of new wheel hub.
...ball joint to the steering knuckle and insert a new O-ring around the hub and bearing assembly. Install the hub and bearing, and shield into the steering knuckle. Tighten the bolts to 70 ft. lbs. (90 ...
...ball joints from lower control arms on each side, separate both outer tie rod ends from knuckle. Drain transmission fluid, pop out both axles from transmission. They can hang. Disconnect shifting ...
921 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
477 Questions