...bleeder valve the clutch lost pedal completely and I mean no pedal at all. I was bleeding it the wrong way at first by opening the valve and then pushing the pedal down. Now doing it the right way by ...
...bleeder valve at the nipple is obstructed with debree. Sometimes if you take the bleeder screw completely out you can remove it and then pump the pedal a bit to get the fluid to come out of the ...
...the clutch in, holds, and you relieve the pressure at the master bleeder, once you tighten the bleeder valve,, the can push the pedal in again, ,, repeat this until all the air has bled from the ...
BLEEDER VALVE ON THE SLAVE BUT CAN NOT GET THE PEDAL TO GET PRESSURE AFTER BLEEDING THE LINE 10 TIMES. TOOK BACK THE MASER CYL. AND GOT A REPLACEMENT. STILL NO PRESSURE AT THE PEDAL. PLEASE HELP. MARC
...bleeder valve located on the internal cylinder with a 7mm wrench and quickly attach the flex line to the valve. I believe this is the wrench you need this is what the size of my ranger is but yours ...
Question about Ford Ranger
...on a 2001 ford ranger 4.0, automatic 4WD with ABS. Before I compresssed the pistons I opened the bleeder screws and removed the cover on the master cyinder. After the installation I bled the front ...
Question about Ford Ranger
...tight no heat in truck take heater hose off then try and blowing the heater core out with a blow gun.or c if there is a bleeder valve on motor some were it has air in it. usaually by thermastat ...
Question about Ford Ranger
...bleeder valve on the radiator wont seal properly and my girlfriend said it would be low on water a lot could this of caused the radiator to mess up go get a new radiatro they cost about 100 to150 ...
...bleeder, press the pedal down to where pressure is felt, then quickly cycle it back and to this point over and over by hand. This gets the air out of the return port in the valve of the master ...
...valve is just a little warm is there a blockage somewhere in the line it sounds like you have a air blockage, or the cooling system needs flushed. to flush system go to ( ...
921 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
477 Questions