1993 Ford F250 "replacing rear brakes" Questions

Ad

brakes spongy after rear caliper replacement, no air in fluid changed one rear caliper and now brakes are spongy to no brakes at all if you keep your foot on the pedal goes all the way to the floor. ...

Ad

...replacing brake pads on the rear wheels. I have medium mechanical ability...radiators, pumps, front pads..etc... If it is a 1986 F250 it has rear drum brakes. Being a 3/4 ton the rear end could be a ...

Ad

...rear disc brakes. BEFORE connecting the bracket of the crossover it is necessary to attach the ends of the rear cables to each rear wheel brake fixture. Since the cables pull the fixtures to tighten ...

...rear brakes are all one system so if air enters through back bleeder screw, every time you release brake pedal it creates a vaccum to pull pistons off of rotors, and during this action air will make ...

Question about Ford F-250

1 Answer

rear brake grab 95 f 250 4x4.. new brakes wheel cylinders drums booster and master cylinder still locks up at low speeds any ideas??? change the hardware , and also flush the system and put in all new

...replacing the rear wheel bearings in my 2008 Ford truck 4x4. I found info on the front, but it's the back I need help with. replacing bearing involves removing axle your not replacing a hub but ...

Question about Ford F-250

1 Answer

rear disc brakes how to remove disc brakes on 2004 f250 Raise the rear of the truck off the ground using jacks. Support the vehicle on both sides with jack stands to prevent it from tipping over. ...

...are probably hanging up.If you are replacing the rear rotors just take a small sledge and beat on the back of the rotor where the dust shield is exposed. I need to find the answer to this same

...brakes every thihg looks good If you replaced the rear brake shoes check the e brake adjuster to make sure it is adjusted/ installed properly. also check that the rear wheel cylinder is in proper ...

Question about Ford F-250

1 Answer

...fine.The next time i drive it the passenger side is hanging up. Scott if rear drum brakes, it may be the brake cylinder on that side. if pads caliper may be sticking and in need of repair or

Not finding what you are looking for?
1993 Ford F250 Logo

391 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...