1990 Ford F150 "tap window motor" Questions

tap on the window motor lightly with a small hammer while holding the switch. If the window moves, replace the motor. If not, check for power and ground at the connector. If you have power and ground

window or what ? i would appreciate any help. there is only one fuse. try removing the door panel and locate the regulator motor. tap on it a few times with a hammer. it will loosen the motor that has

...window motor. Round with wires coming out. This is the actuator motor for the four wheel drive. A lot of times if they are not used the brushes will stick in the motor and if they do the four wheel ...

tap but doesn't allow me power to start. If left alone with headlight switch on, it eventually clears itself. But sometimes I have to disconnect battery to reset. (if anyone can tell me where the main

...window motor out... i took the door skin off and it looks like its been rivited? i need to know how to take it out and replace it? It's common for these to be riveted. You'll need to drill out the ...

...window switch, and, with a large plastic or rubber mallet, tap on the inside of the door panel. The tapping may just free up the brushes, and the motor may start to work. In severe cases, the door ...

...tap bottom of the door while holding the window button either up or down depending on the position of the window. Be careful as you don't want to dent the outside of the door with the mallet. If the ...

2001 Ford Windstar. Both front windows will not work. There is power to both motors. What else can I check. try tapping the motors with a small hammer the motors are probably corroded by tapping them ...

...will not roll down. using 12 volt test light back probe motor connector work switch up and down light should illuminate both terminals if so hold window button down small hammer tap directly on ...

...windows work. can it be a fuse for just that window? no the motor is stuck remove the back door panel then the 15 screws to acces the motor try tapping the motor while having someone work the ...