1990 Ford F150 "1996 throttle position" Questions

1996 Ford F150 4.9l 5spd. Engine starts and idles very rough. problem started out intermitent months ago and till now would clear up after about 10 sec. or if I would rev past 2 grand. Now it will not

1996 f150 with a 4.9 6 cyl. it takes ether to start it then will idle but when you accelerate at all it dies. weve tuned it up, mapp sensor ok, throttle position sensor ok, what can it be? yes checked

1996 Ford F150 Super Cab wont start without stepping on the gas pedal and when you put it into gear it dies..please help!! I would check your fuel pressure at the motor on the fuel rail see if you are

sticking or mass air flow and possible Throttle Position Sensor. Have had all 3 give me trouble with 5.0 in the past. Clean EGR,and if its the same, check TPS with ohms meter, needle type are the best

...throttle relay, does a 1996 ford f150 xl have a wot relay?? if it does, where is it located?? Any suggestions of what it could be? Assuming you have the system adequately pressurized with gas, check ...

1996 f-150 inline 6 bi feul will not start after engine is warm. I can't figure out why. if I spray starting fluid in air breather it will start. fuel pressure is running 35psi I have put new ...

...throttle position sensor? Considering the regulator has no effect on starting lets save that for later. You are surely getting too much fuel. Try unplugging the TPS (hot, cold, and startup). The ...

my truck will miss and hesitate at highway speeds when i drive my truck at around 50+ it will miss and hesitate and i would have to give it gas to smooth it out. ive replaced the throttle positioning ...

1996 f150 5.8 4x4 idler controll,fuel Syestem is good Changed throttle sensor,mass .Whole distributor,wires,Plugges.Engine will run ruff with mass unplugged & soon after reconnecting the mass,go dead ...

...1996 f150 reg cab with dual fuel tanks. This has the 4.9 6 cyl. Truck runs great until it hits normal operating temperature, then it will miss and buck for a short time then starts running normally ...