...blower motor speed control resistor, the thermal limiter is most likely blown in the resistor, the resistor is located next to the blower motor, see picture below, the aprt is very cheap to buy and ...
...plug pin were burt out but still the blower motor is wrking poorly, any ideas? your blower motor my be bad or sometimes you can get a bad resistor try another resistor if that dont do it try the ...
...blower only works on high. Replaced the resistor no difference.Checked fuses OK. What else could it be. The resistor has a thermal limiter in it, if its bad, it cannot be reset. The blower motor may ...
...with test light check for power and ground at the connector. If signals are good, replace blower motor. If signals are not good, possible blower resistor failed , fuse , relay , controller,
...xlt 402 engine where is the resistor bank for the heater blower located. this is a 4by4. It is located in the blower housing itself, somewhere near the blower motor...should be 2-3 screws holding it ...
...blower resistor on 2001 ford ranger Under the hood , passenger side a t the fire wall. next to the blower two or three screws hold it in. It will have three or four wires going to it depending on how ...
...resistor is located next to the blower motor which is located under the dash on the passenger side. the resistor is held into the caseing with two screws. There is a three wire connector attached to ...
...blower motor resistor location and difficulty repacing the resistor is located under the hood, in the black electrical box. There is a drawing of all that is in that box in the owners manual -- if I ...
...blower motor resistor. It is located near the blower motor. The resistor has a series of individual resistor that reduce the power to the blower and make it turn slower. If the medium resistor is ...
671 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions
