1989 Ford Econoline "remove hubs edge" Questions

...edge of the rim, but be careful not to rap it to hard, as you might dent the rim.It won't hurt to grind a little bit, just enough to remove the rust. I do it all the time.Hope I could help out. my ...

...remove auto hubs on 84 4wheel drive pu need help removing auto hubs on a 84 1/2 ton 4wheel drive pu there should be 5 or 6 allen bolts around hub. remove these and cover will come off then there is a ...

remove rear hub assembly Removed rear car wheel and brake drum. Also removed ABS cable and 4 bolts from the rear hub assembly. PBlasster and Liquir wrench soaked edges of hub assembly, both from ...

...remove the hub assembly. Install the new assembly and thrust washer, tighten the new nut to torque 134 lbs, then stake in the edge of the nut (opposite of unstaking). Tap the dust cover into place, ...

...hubs? Jack up the axle and secure it. Remove the rim and tire. Remove the caliper. Remove the manual hub cover (the part that engages the hub) by removing the small Allen head bolts.Remove the big ...

...hubs. Dana 44 axle. Yours may be similar. For front wheel, remove locking ring just inside the inner edge of the hub housing (once you remove the manual hub locking switch, 6 screws on mine, could be ...

...Remove any retaining rings on the hub of the rotor around the studs. Pry them off with the screwdriver and discard them. You will not need them for reinstallation. Strike the fin of the rotor on the ...

...remove inner cv boot, just on inside edge is circlip which holds inner bearing joint into outer housing remove circlip and separate joint outer housing does not come out of front diff unless you drop ...

Rear brake rotor heating up on 2008 awd edge. 60000 klms on vehicle. Removed wheel for inspection. Rotor moves but there is resistance to turning. those are the ball bearings of the wheel hub needs to

...edge of instrument panel. Remove glove box and hinge bar from instrument panel. Pull right register duct from installed position between air inlet duct and right register opening, Fig. 10. Remove ...