1987 Ford Crown Victoria "engine oil" Questions

oil change and run the engine for about 5 minutes (DO NOT DRIVE THE CAR!) then drain the oil and install a NEW high quality oil filter and fill the oil back to where it should be on the dip stick. The

...engine's oil pan. At it's lowest point there will be an angled bolt. Carefully loosen the bolt (counterclockwise rotation). Expect a healthy stream of oil to flow out quickly. Dont drop the bolt, it ...

...engine light. The oil level is full and has not been run low. One of two problems. Bad oil sensor on the block or oil pickup tube in engine is plugging up. The sensor is not expensive,the oil pickup ...

...new oil pan side gaskets on the block Make sure the tabs of the front and rear seal fit properly as these are critical spots Attach the oil pan to the engine block and install the retaining ...

2001 Crown Victoria 4.6 ticking noise coming from engine. Oil lamp and check engine light on. Low on oil, dirty oil or oil pump may be weak.

...engine speeds, oil light comes on when engine is warm. one other thought was that you say it was running for 5 mins before oil light went out-did it sound bad? ticking or knocking like it really did ...

...ford crown victoria. thank you KNOCKING NOISE IS NOT A GOOD SIGN.SOUND IF YOUR ENGINE OIL LEVEL IS CORRECT NOT LOW. SOUND LIKE OIL PUMP AND MAIN BEARING FAILURE.YOU NEED A REBUILT ENGINE OR OVER

engine oil. Connect the negative battery cable and install the air inlet tube. Start the engine and check for leaks. Have a MVAC-trained, EPA-certified, automotive technician evacuate and recharge the

engine problem ok what happen is the oil presser gauge was bousing up and down and my roomates and i really did not know what was happening and we kept driving well when i was at a friends house i was

...oil is not going to the tintioner when engine is hot What year?? If 2003 or earlier, then you need to replace the timing chain guides/tensioners. BUT you said of no oil going there (do you have oil ...