...for both right and left and replace them. Tighten in the same cross pattern and be careful no to pinch the
...pinch bolt on the sensor pedestal until the sensor is free to slide. Remove the pedestal to the engine mounting bolts. While manipulating the sensor within the pedestal, carefully remove the sensor ...
...pinch bolt on the sensor pedestal until the sensor is free to slide. Remove the pedestal to the engine mounting bolts. While manipulating the sensor within the pedestal, carefully remove the sensor ...
...clue but im hoping it is not my tranny if its a manual then you have moved the splined shaft under the car ,just re adjust it ,slacken pinch bolt and look for original marks in the grime to re set ...
...fuse Look for a part of that wire cable that is rubbing on metal somewhere or that some mechanic pinched under a bolt or drilled a screw through. It may take some time but the closer you look at ...
...to some part of the rear end, just follow this hose to its end and make sure its not clogged or
Question about GMC Cars & Trucks
...pry it up, just enough to get at the pinch bolt? Is there a keeper or anything holding the bottom of that boot? You may have to get rough with it? My biggest problem is I can't see anything from
...pinch bolt of knuckle. Get it started and we used a rubber mallet to somewhat gently persuade it into place. Once it was lined up we rapped the joint area while shaking the knuckle/strut and it ...
...and spark checker on. Turned it over and it fired right up. Any thoughts on this problem? Check for pinch wires and unplug and inspect all connections you previously touched. check wires touching ...
fule pouring out no i only took off the short pressure line from the filter to the tank . i did not take the tank completely out just dropped the font end of it so i could get to the line. before i ...
598 questions posted
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions