1999 Pontiac Bonneville "removing lower bolt starter 99" Questions

lower air deflector Torque converter cover Electrical connections from the starter Starter motor To Install: Install or connect the following: Starter motor and torque the bolts to 32 ft. lbs. (43 Nm)

lower side of engine to the starter. Disconnect battery wire from starter. Loosen & remove the (usually 2) retaining bolts holding starter to engine. Remove starter with a back and down action. To

...bolt. Tighten the bolts to 32 ft. lbs. (43 Nm). Attach the wires to the solenoid and lower the vehicle. Connect the negative battery cable. Four Wheel Drive except utility models Disconnect the ...

removing the last bolt, be sure to support the starter to keep it from falling and possibly injuring you. Carefully lower the starter and shims (if equipped) from the vehicle. If necessary, remove the

...assembly. Disconnect the (A) S-terminal wire, and the (B) B-terminal nut and cable from the starter motor. 6. Remove the lower starter motor bolt and remove the starter motor and solenoid

...Lower starter down and out, or maybe even up through the top, which ever way you think is the easiest. you may need to manipulate it, turning it around so that it will come out. Replace the new one ...

bolt to clear the knock sensor. Re-do the electrical connections. Try the starter before lowering the car. If the starter binds, or makes a loud noise, add shims until it sounds normal. Re-install the

...bolt Starter solenoid shield Protective shields as necessary Remove the safety stands. Lower the vehicle. Connect the negative battery cable. 5.7L And 7.4L Engines Before servicing the vehicle, refer ...

...removing the pan. If the pan is removed first, damage to the sensor may occur. Remove the oil pan-to-engine bolts and the oil pan. Remove and discard the oil pan gasket. The formed rubber oil pan ...

...bolt to 9 ft. lbs. (13 Nm). Install the nut and washer. Install the control shaft shift lever. Connect the electrical connector. Install the front exhaust pipe. Torque the front nuts to 46 ft. lbs. ...