...are dragging on my rotors i think my piston on my caliper is stuck how do i fix it please help me replace the caliper. rotor, and pads the fuse for turn signal always burning can you help me ...
Question about Nissan Maxima
...stuck position again when brake is applied a few times, and then it must be bled to release the piston pressure again. if the caliper is ok it sounds like the flexiable hose is restrcted by the metal ...
...can it be can it be my e brake The caliper is probably stuck, I had to replace one of mine, drivers rear. The piston on the caliper screws back in, so you'll need a caliper press to seat the
...brake is off on car,cap is off on m/cyl,screw typ pistons on rear calip.bought box type special tool to compress piston,3/8 rachet applied pressure,while turning clockwise piston will compress in why ...
...brake. The caliper is not stuck, you need a special tool to rotate the piston of the brake caliper and depress it down. It is connected to your parking brake, that is why this security measure was ...
Question about Nissan Maxima
...stuck piston with a brake piston removal tool and bleed fresh fluid through the system. Could be the caliper. Look at the brake pads. Are they wearing even or at an angle? At an angle means that the ...
...brake pads but the caliper pistons seem to be stuck! is there any way they are tied into the front brakes r is this just stuck caliper pistons???? need help asap!!!!!!!!!!!! On cars with 4 wheel disc ...
Question about Cars & Trucks
...piston back in to a brake calliper on a 1993 ford taurus brake sezied up and stuck on had to reless the piston use a C-clamp to push the piston back in but make sure the brake fluid filler cap is
Question about Honda Cars & Trucks
...stuck in the cylinder or internally collapsed brake line are possibilities . Brake piston is sticking by sounds of it, pump out piston but not to far it pops out, check for corrosion, replace caliper ...
brake caliper repair. Hope this help (remember rated and comment this). You normally don't fix them, they can be honed and new seals put in but it is common practice to replace it as a pre loaded unit
1,228 questions posted
Usually answered in minutes!
1,309 Questions
1,122 Questions
1,007 Questions
783 Questions
480 Questions