1995 Nissan King Cab "procedure removing cylinder head" Questions

...procedure from Autozone.com below. I've never seen such a complicated way of getting the tension right, but better to follow their instructions, I guess. Note that they ask you to loosen the rocker ...

procedure. REMOVAL 1. Drain engine coolant from radiator and cylinder block by removing the drain plugs. 2. Remove the intake manifold. 3. Remove exhaust manifold. 4. Remove camshafts. 5. Remove valve

...procedure shows to remove the intake manifold in order to access the sensor from the top, however it is also possible to access from the front by removing the air cleaner, thermostat and alternator. ...

procedure.
sprocket using Special Tool 8429 Timing Chain Holding
Fixture (Fig. 6).
NOTE: Mark the secondary timing chain prior to
removal to aid in installation.
(16) Mark the secondary

..... what is the procedure to remove & inspect the lifters or, if necessary, remove the cylinder head? if your cylinders filled up with coolant ...you have a blown head gasket or, cracked engine ...

...Cylinder Head Cover - REMOVAL & INSTALLATION procedure... 1. Remove the air cleaner assembly. 2. Disconnect the PCV hose(s) from the cylinder head cover. 3. Remove the nuts and washers. Lift the ...

the cyinder head bolts torque Removed the cylinder head after the cylinder head gasket blew off You should find the torque procedure with your new head gasket. Haynes manual would be a good investment

...cylinder head or valve cover. Relieve the fuel pressure using the proper procedure. Disconnect the fuel lines. Disconnect the accelerator cable at the throttle body or carburetor. On automatic ...

...Cylinder Removal WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR DRIVER SIDE AIR BAG MODULE DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, ...

...Cylinder Head Removal. The procedures for removing the rear (Figure 3) and front (Figure 4) cylinder heads are nearly ... videos that might help ...