Question about Ford Crown Victoria
...right rear axle on a 2004 ford crown vic to replace seal on wheel? Section 05-02A: Axle, Integral Carrier ? 8.8-Inch Ring Gear 1994 Town Car, Crown Victoria/Grand Marquis. Workshop Manual REMOVAL AND ...
...right beside it here is a picture from autozone.com and description. The crankshaft position sensor identifies position of the crankshaft to the ignition control module (ICM), engine control module ...
Question about Pontiac Cars & Trucks
...right (passenger side) of 4 cyl. engine after car is parked. Oil splatter all over right side of engine. Where could the leak be from? May be related: The right side squeaks when the wheel rotates. ...
...4-2-5-3-6 Good luck if you are over the right fender its the first spark plug in the back wish you the best of luck Michigan Man. loosing oil under rt/side under the power sterring pully/waterpump ...
...right center of engine compartment. find your oil filler cap and look lower. its a black oil filter housing. 1"1/4 socket fits it or your can get a special socket for this housing at oriellys for ...
4 10mm bolts 1 is hidden Lower right side Pump front now your oil pump will be loose to remove off pull forward to front of truck....I find that pouring Lucas engine oil stabalizer into the pump where
...4 cyl. How the heck do you find the oil filter? I know about where it is but don't see it and can't feel it. The oil filter is located just in front of the right side drive axle. (Passenger side) It ...
...right side of intake manifold. Use a 32 mm (1 1/4 in) socket on the hex on top of the oil filter cap, or an oil filter wrench on the outside diameter of the oil filter cap. Remove the oil filter cap ...
...at the lowest back side of the oil pan and on top of the car the oil filter is about 6 inches forward and right of the oil filler cap and is a black plastic cap with a hex head measuring 1 1/4" ...
Question about Cars & Trucks
...4 cup oil across paper on right side. good engineering practice dictates that the head should be skimmed flat and new head studs used further more the stud holes should be cleaned with a thread tap ...
210 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions