2004 Ford Explorer "rear upper" Questions

Ad

...rear is off the ground. For the front Remove the wheel. Take off the upper shock nut. Now remover the two lower retaining nuts. Compress the shock and pull it out. Install in reverse order. Before ...

Ad

Question about Ford Explorer

1 Answer

upper intake manifold in the rear. It is locate in the lower intake manifold in the rear right below the upper intake manifold. It is really hard to see but if you get a mirror you can probably see it

Ad

Question about Ford Explorer

1 Answer

pcv alve location 1998 ford explorer sport 4.0 liter I'll do my best to explain it. It's under hood center, rear engine area, mounted on upper rear of engine block. I hope this helped and good luck.

How do you replace the rear brake lamp across the upper rear door There should be "push pins" into the plastic housing or an access door. They don't make them real easy to change. Hope this helps !

Question about Ford Explorer

1 Answer

rear door window glass as described in this section. Remove the window guide, if equipped, (nuts and washers). Remove guide from door belt opening. Remove three 1/4-inch rivets attaching motor bracket

...upper brake light works fine ...... whats wrong ??? check the rear lower bulbs, if good nore than likely brake lamp switrch on brake pedal, 3rd lamp rns of separate circuit Do the rear turn signals ...

...my right side, third row seat belt and it was coming from above. Seemed like it was from somewhere around the rear hatch. ANY IDEAS? Take out the head liner and check for bad welds on the upper ...

...rear upper control arm ball joint on a 2004 Explorer? I am replacing the bearings in the hub and discovered that the upper control arm ball joint is loose. Do I need to take the whole control arm off ...

...rear suspension upper arm to prevent boot damage when removing the halfshaft assembly from the vehicle. Using a wood stick, approximately 450 mm (18 in) long and 25 mm (1 in) wide, support the rear ...

0 1996 Ford Truck Explorer 4WD 4.0L EFI 6cyl the Camshaft Position Sensor is located: Under hood, center, rear engine area,mounted on center upper rear of engineblock Remember to rate this and comment

Not finding what you are looking for?
2004 Ford Explorer Logo

2,501 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2003 Ford Explorer
2003 Ford Explorer

1,369 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...