how do i get brake rotor off? do i need to take axle nut off? once the caliper is off and the rotor won`t come off then you will have to hit the rotor with a hammer near the wheel studs to loosen it ...
...like the frame are the axsil. The ball joints are located in the the steering knuckle below the axles and the balljoint stud goes through the lower control arms. Balljoint location here is a pic ...
...to be knocked out of it from the side the tire studs are poking from to the other side where the axle is. When you replace then, load them full of bearing grease....set it in place and use a board ...
...stud cover. NOTE: Remove rust from the rotor and hub mating surfaces with a medium abrasive pad. Install front disc brake rotor and disc brake caliper . Tighten caliper anchor bracket bolts to 88-118 ...
...axle shaft nut. Remove 3 bolts securing hub assembly to steering knuckle. Pull hub straight back from knuckle. If hub is corroded, pry between hub flange and knuckle Fully remove knuckle pinch bolt. ...
...axle assembly in toward the transmission, when you get it in far enough for the ball joint to line up, ease the pressure off the prybar and allow the ball joint stud to go in the hole on the
...stud is convex and the spindle is concave; they fit together in what's called a mechanical weld. Even after the nut is removed, the ball joint will not come out without breaking the mechanical weld. ...
...are pressed into the axle or hub , remove the axle or hub press out the broken stud , press in a new stud , make sure the head of the stud is pressed in to its full depth. then refit the axle or
...wrench ,crank the stud down. The splines on the stud will bite in , keep turning until stud base meets axle flange. A new lug nut may be required , the one you use as an install tool may get
2,993 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,120 Questions
1,431 Questions
1,365 Questions