2001 ford taurus First you need a lot of tools second you have to disconnect the transmission drive axles and remove the transmission from the vehicle jack stands engine crane slide hammer with puller
2001 Taurus to dealer and was told timing cover gasket, transmission pan gasket, and axle seals @ transmission all need to be replaced. Does leak a very small amount of transmission fluid on driveway.
...2001 ford taurus Please don't forget to rate: Bleeding The Brake System Bleeding When any part of the hydraulic system has been disconnected for repair or replacement, air enters the lines causing ...
replace lower ball joints on a 1997 taurus If you don't have a 'Ball joint splitter'. You won't get very far. But, if you do. It's not too taxing a job. Firstly you need to locate the two fixings, ...
2001 kia rio, replaced drivers side axle. axle on passenger went back into transmission with no problem. Drivers side (new axle) will not lock into transmission.There is a ring on the end of the axle ...
Question about Ford Taurus
replaced? I have a 2001 Isuzu trooper 4wd. The front cv axles and boots need replaced. Is it bad to drive on them like is and if so how bad? Also I heard you can drive some 4wd without cv axle is that
Have a 2001 Buick LeSabre. Vibration turning left . Think it may be CV Joint. How do I pull the axle out to check CV Joint? Rasie vehicle, remove tire, axle nut and caliper. remove tie rod end from ...
Question about Dodge Cars & Trucks
I need a diagram of a 2001 dodge ram 1500 four wheel drive front axle I need a diagram of a 2001 dodge 1500 four wheel drive front axle Search Results Images for I need a diagram of a 2001 dodge 1500 ...
Question about Ford Taurus
...2001 Acura MDX, I had the rack and pinion, and right-side axle replaced 2 weeks ago. Now I noticed, when I accelerate suddenly, there's a bit of a vibration on the steering. My mechanic says that ...
...2001 kia spectra, need to replace both front axles. do they need to be pressed on? thank you. They shouldn't need to be pressed in but there is a stubborn ring on the end that goes in the transmision ...
2,993 questions posted
Usually answered in minutes!
2,347 Questions
2,262 Questions
2,120 Questions
1,431 Questions
1,365 Questions