2000 Ford F250 Super Duty Crew Cabs "undo blocked plug" Questions

...a frost plug not a cracked block from your description. No, motor dies not have to come our, but you have to undo motor mount, raise block slightly and support and pound out & in new first

Where is the coolant drain plug in block? i have NEVER seen a block drain plug on any *** car.you have to undo the jubilee clip on the bottom hose of the radiator...

...able to flush the coolant if the plug is not remove is there an easier way to get the plug out THERE IS NO REASON WHY THE PLUG SHOULD NOT UNDO, BUT NO YOU CANNOT FLUSH THE ENGINE UNTIL YOU DO REMOVE ...

...spin it over if it sparks then undo the fuel line to engine and if nothing coming out when you turn the key then you have a blocked fuel filter replace and try again ,,that should fix your

...box. it will be located under your air work. you will have to take the air intake hoses off, undo the two phillips screws to your throttle cable mount, undo the 6 or 8 bolts, i believe the

...to replace an intake manifold gasket on a 2002 hyundai elantra Remove the intake tube, maf, etc. Undo the fuel line into the rail. be careful fuel will spray if the car has recently ran. cover it ...

...plug and undo coonecting rods, inside door at front of handle is a little cir clip holding a pin through handle, remove both, you should now be able to wriggle handle out to the inside of the car ...

...plug placement is the same. It helps to remove the coils to gain access to the rear plugs. Other than that an assortment of extensions, a flex handle ratchet, a mirror and a lot of patience. I think ...

plug" or whatever the tech name of the part is to drain it. UNDO THE BOTTOM RADIATOR HOSE AND TAKE THE TOP HOSE OFF AT THE BLOCK TO REMOVE THE THERMOSTAT THEN YOU CAN FLUSH THE ENGINE AND THE RADIATOR

...plug. Any help would greatly appreciated. hello. there is a very small kind of screw just in the lowest part of the radiator, just remove it. if you don't see this so clear just do it ...