1999 Ford Taurus "stripped axle" Questions

...no fouard and reverse the gearboox is neutral no forward and reverse if the vehicle does not roll in park(looking for broken axle) it's most likely cause is a stripped out torque converter

...into gear from park. gear lever will move. does this roll in park that should rule out a broken axle if not it probably has a stripped out spline for the pump shaft. if so the trans has to come

...stripped the splines on the shaft or on the hub which is pretty hard to do.  Considering it takes a puller to get it off and that nut with the cotter pin pretty much presses it on. There are ...

stripped pump drive spline in the torque converter.If the car has 80,000 miles or less the you may only need to replace the torque converter and front seal.I would recommend replacing filter and fluid

...stripped spline on power shaft may be a striped axle stub or a broken cv joint. but a bad trans is just as likely. have someone look under the car from the side at the axles. then start and put in ...

...tell if you mean inside the differential, with the axle, or at the wheel? In general the axle is fairly easy to remove, but what it goes onto at either end is more complex if that is what is

Stripped axle end cant get axle bolt on need a answer with out buying a another axle Tap to the next smaller size. Use a nut of 10.9 hardness and a large washer behind it.

...axle flange. You said the stud was stripped. You can: Force one of the lug nuts onto the stripped stud maybe two to three turns , then take a drift pin and drive the stud out the back. The stud will ...

Mr car is making a loud metal grinding noise when put in gear to go forward what's wrong You could have broken the axle shaft. It can break in the cv joint and just spin or on some models the axle ...

...axle spline is stripped and I need to change it. Thanks in advance Lift and support front end on suitable jack stands preferably on frame. Remove right front cv axle, stub shaft, and seal. You will ...