1999 Ford Explorer "pressure psi conversion" Questions

...on the sticker located on the drivers side door which i did. but the measurement is not in psi,its in KPU ,which i dont know the conversion for. 31 PSI ...

psi on the low pressure side. You can buy a cheap gauge with a can of R134A at any good store. System usually holds a couple of pounds. start there. ------------------------------ SECTION 412-03A: Air

...pressure from kpa to psi Google has an auto convert facility (for almost anything), simply type.... convert *insert number to be converted here* kpa to psi and google will convert it for you.

...wire harness new computer hypertech chip and reads a steady 45 psi of fuel pressure Not enough fuel pressure. Or the injectors are too small. I would lean to the injectors and the fuel you

...psi and disengages. Then the pressure builds back up to 54 psi and the clutch engages again. Question 1. Is this the way it's supposed to work, and if so, did I over charge the system? #2. If I ...

pressure slow rise to 40 psi, normal? new fuel filter, can hear pump running in tank. bad stumble trying to get on the gas. new MAP sensor i'm not sure what the psi from the pump should be, but it

gasket pressured the cooling system. with a radiator tester pressure the system to 15 PSI it should hold this pressure . if not check for external leaks if no leaks , cracked head or blown head gasket

...precise. If the engine is not having bearing noise I can see nothing to worry about. You are looking at an electrical signal to psi conversion. I suggest installng an aftermarket oil pressure gauge. ...

...pressure on your car should be 392 - 550 kPa or 56.9 - 80.4 psi at 3000 rpm and at normal operating temperature of about 80 degrees C or 176 degrees F. If you need a conversion calculator just google ...

...psi.i have checked the boost pipes connections all seem to be tight and there seems to be no leaks. the place that did the work on the turbo say what they did shouldnt affect the boost as they just ...